Discover XQ-Power Servos in Our eBay Store!
Shop Now
Technical Specifications
Last Updated: 2026-07-28Identity
Performance
Physical
Drivetrain
Control & Signal
Electrical & Environment
Connectivity
Origin
Preferences are saved automatically.
| Identity | |
| Brand |  |
| Product Number | JRPSZ9100HVT |
| Category | Hobby |
| Discontinued | Yes |
| Performance | |
| Torque |
7.4V480.00 oz-in34.56 kg-cm3.4 N-m |
| Speed |
7.4V0.12 sec/60°500.0 deg/s83.3 RPM |
| Running Current | (add) |
| Stall Current | (add) |
| Shaft Power | 7.40 W |
| Physical | |
| Weight | 2.60 oz73.7 g |
| Dimensions |
L 1.58 in W 0.82 in H 1.57 in L 40.1 mm W 20.8 mm H 39.9 mm |
| Case Material | (add) |
| Drivetrain | |
| Motor Type | Coreless |
| Motor Drive | (add) |
| Gears | Metal |
| Gear Spline/Teeth | 23 T estimate |
| Rotation Mode | (add) |
| Rotation/Support | Dual Bearings |
| Backlash | (add) |
| Control & Signal | |
| Modulation | Digital |
| Direction | (add) |
| Rotational Range | (add) |
| Mechanical Limit | (add) |
| Pulse Cycle | (add) |
| Pulse Width | (add) |
| Neutral Position | (add) |
| Dead Band | (add) |
| Refresh Rate | (add) |
| Angle Sensor | (add) |
| Control System | (add) |
| Programmable | (add) |
| Signal Voltage | (add) |
| Electrical & Environment | |
| Operating Voltage | (add) |
| Power Source | (add) |
| Regulator Type | (add) |
| Temperature | (add) |
| Water Rating | (add) |
| Certification | (add) |
| Idle Current | (add) |
| Connectivity | |
| Connector | JR (Universal) |
| Wire Length | (add) |
| Origin | |
| Country of Origin | (add) |
Disclaimer: Most data is sourced from the manufacturer. Some data is sourced from our loyal community and with the help of AI. We aim for accuracy but are not responsible for inaccurate information.
Quick Actions
Similar Active Servos
Reviews (1)
-
Jacob
September 26, 2013Application(s): Front and rear on modified wraith
Comments: I was really disappointed with these servos. I bought two for my wraith (front and rear) and within a couple days both had broken gears. The teeth on the main out put gear and the top center broke off (they didn't even strip, the teeth sheared right off). I also bought two sets of replacement gears and after a few runs they broke as well. Contacted JR and they would only send me one set of gears for both servos. I'm disappointed in the servos and in the company. Don't waster your money on these. I should have just stuck with my hitec 7950s.