Discover XQ-Power Servos in Our eBay Store!

Shop Now
Hyperion DS20x-SMD
Standard Discontinued

Hyperion DS20x-SMD

Compatible Hardware

*Based on known specs.

Technical Specifications

Last Updated: 2026-09-04
Identity
Brand Hyperion
Product Number DS20x-SMD
Category Hobby
Discontinued Yes
Performance
Torque
6.0V 222.20 oz-in
4.8V 194.40 oz-in
Speed
6.0V 0.11 sec/60°
4.8V 0.13 sec/60°
Running Current
6.0V 0.300 A
4.8V 0.230 A
Stall Current 1.5–2 A
Shaft Power 2.77–3.74 W
Physical
Weight 1.85 oz
Dimensions L 1.57 in
W 0.77 in
H 1.44 in
Case Material Plastic
Drivetrain
Motor Type Coreless
Motor Drive (add)
Gears Metal
Gear Spline/Teeth (add)
Rotation Mode (add)
Rotation/Support Dual Bearings
Backlash (add)
Control & Signal
Modulation Digital
Direction Clockwise
Rotational Range 90°
Mechanical Limit 140°
Pulse Cycle (add)
Pulse Width (add)
Neutral Position 1500 µs
Dead Band 2 µs
Refresh Rate (add)
Angle Sensor (add)
Control System PWM
Programmable Yes
Signal Voltage 2.5-5V
Electrical & Environment
Operating Voltage 3.5–7.8 V
Power Source (add)
Regulator Type (add)
Temperature -20–60 °C
Water Rating (add)
Certification (add)
Idle Current 0.007 A
Connectivity
Connector Futaba J estimate
Wire Length (add)
Origin
Country of Origin (add)

Disclaimer: Most data is sourced from the manufacturer. Some data is sourced from our loyal community and with the help of AI. We aim for accuracy but are not responsible for inaccurate information.

Similar Active Servos

Reviews (3)

  • Ehh Man

    September 16, 2013

    Application(s): Trex 550 cyclic

    Comments: Good high resolution servos. Gear trains sometimes have "gritty" spots due to tight gear mesh but the gears will break in and smooth out after a few dozen flights. If your radio system has any jitter in the PWM signal these servos will try to move in response to it and will jitter and buzz. This can be eliminated by raising the deadband slightly higher than the jitter so the servo ignores it (this is the fault of the radio system not the servo) Hyperion doesn't sell cases for these but you can use an Airtronics 94842 case (both servos are made by the same manufacturer)

  • Silicon-Surfer

    July 26, 2012

    Application(s): T-Rex 600E Pro Helicopter

    Comments: I installed 3 of these a cylic servos on my T-Rex 600E pro, and couldn't be happier. They have heaps of torque, perform flawlessly and the price is excellent! Highly recommended!

  • DrFizz2k1

    June 18, 2010

    Application(s): HPI Blitz SCT

    Comments: Installed easily, performance is excellent, super fast, lots of torque. outperforms my previous "best" servo (ACE DS1313) with ease. At about half the price of comparable servos from other companies, I'm for sure going to buy more!

Submit a review of Hyperion DS20x-SMD