Discover XQ-Power Servos in Our eBay Store!

Shop Now
Hitec HS-5625MG
Standard Discontinued

Hitec HS-5625MG

Compatible Hardware

*Based on known specs.

Technical Specifications

Last Updated: 2026-09-14
Identity
Brand Hitec
Product Number 35625S
Category Hobby
Discontinued Yes
Performance
Torque
6.0V 131.00 oz-in
4.8V 110.00 oz-in Below Average
Speed
6.0V 0.14 sec/60°
4.8V 0.17 sec/60° Below Average
Running Current
6.0V 0.500 A
4.8V 0.400 A Below Average
Stall Current 1.7–2.1 AAbove Average
Physical
Weight 2.11 ozAverage
Dimensions L 1.59 in
W 0.77 in
H 1.48 in
Case Material Plastic
Drivetrain
Motor Type 3-pole
Motor Drive MOS
Gears Metal
Gear Spline/Teeth 24 T
Shaft Size 6.0 mm
Rotation Mode Positional
Rotation/Support Dual Bearings
Backlash 0.500°
Control & Signal
Modulation Digital
Direction Clockwise
Rotational Range 120°
Mechanical Limit 175°
Pulse Cycle 20 ms
Pulse Width 900-2100 µs
Neutral Position 1500 µs
Dead Band 1 µs
Refresh Rate 50 Hz
Angle Sensor Potentiometer
Control System PWM
Programmable Yes
Signal Voltage 3-5V
Electrical & Environment
Operating Voltage 4.8–6 V
Power Source LiFe
Temperature -20–60 °C
Water Rating IP40
Idle Current 0.003 A
Connectivity
Connector JR (Universal)
Wire Length 300 mm
Origin
Country of Origin Philippines

Disclaimer: Most data is sourced from the manufacturer. Some data is sourced from our loyal community and with the help of AI. We aim for accuracy but are not responsible for inaccurate information.

Class Comparison

TorqueBelow Average
Stronger than 20% of 1043 Digital Standard servos at 4.8V
SpeedBelow Average
Faster than 28% of 1041 Digital Standard servos at 4.8V
WeightAverage
Lighter than 63% of 1902 Digital Standard servos
Running CurrentBelow Average
Lower draw than 31% of 173 Digital Standard servos at 4.8V
Stall CurrentAbove Average
Lower draw than 86% of 539 Digital Standard servos

Performance Analysis

Shaft Power 1.20–1.73 W
Power Density0.955 W/in³
More power-dense than 16% of 1759 Digital Standard servos
Torque Density1.8395 oz-in/g
Stronger than 18% of 1036 Digital Standard servos
Torque-to-Volume Ratio60.71 oz-in/in³
Denser torque than 21% of 1042 Digital Standard servos
Speed-to-Weight0.09837 (1/sec·g)
Faster than 33% of 1033 Digital Standard servos
Speed-Torque Trade-off18.70
Better balanced than 34% of 1031 Digital Standard servos
Current-per-Torque Ratio0.0191 A/oz-in
More efficient than 36% of 315 Digital Standard servos
Idle-to-Running Current Ratio0.008
5th-highest idle-to-running current ratio of 112 Digital Standard servos
No-Load vs Stall Current Spread5.25
Narrower current spread than 84% of 132 Digital Standard servos
Torque Gain per Volt15.91%/V
More voltage-responsive (torque) than 52% of 850 Digital Standard servos
Speed Gain per Volt17.88%/V
More voltage-responsive (speed) than 68% of 871 Digital Standard servos
Voltage Range Width1.2 V
Wider voltage range than 22% of 1539 Digital Standard servos
Backlash-to-Range Ratio0.00417
Tighter backlash than 59% of 23 Digital Standard servos
Dead-Band-to-Pulse-Width Ratio0.0008
Finer dead band than 92% of 468 Digital Standard servos

Similar Active Servos

Reviews (2)

  • Oliver

    May 14, 2019

    Application(s): Steering servo for HPI trophy flux

    Comments: Extremely smooth and fast with loads of torque! Definitely would buy again

  • Per P

    November 2, 2018

    Application(s): Aileron servos on my jet

    Comments: One of the most smooth running servos I have ever seen in my 25 years as a modelflyer. Centering is accurate. I will definitely buy more of these!

Submit a review of Hitec HS-5625MG