Discover XQ-Power Servos in Our eBay Store!

Shop Now
Futaba S9254
Standard Discontinued

Futaba S9254

Compatible Hardware

*Spec is estimated from brand data.

Technical Specifications

Last Updated: 2026-07-28
Identity
Brand Futaba
Product Number FUTM0224
Category Hobby
Discontinued Yes
Performance
Torque
4.8V47.00 oz-in
Speed
4.8V0.06 sec/60°
Running Current (add)
Stall Current (add)
Shaft Power 1.45 W
Physical
Weight 1.73 oz
Dimensions L 1.57 in
W 0.79 in
H 1.46 in
Case Material (add)
Drivetrain
Motor Type Coreless
Motor Drive (add)
Gears Plastic
Gear Spline/Teeth 25 T estimate
Rotation Mode (add)
Rotation/Support Dual Bearings
Backlash (add)
Control & Signal
Modulation Digital
Direction (add)
Rotational Range (add)
Mechanical Limit (add)
Pulse Cycle (add)
Pulse Width (add)
Neutral Position (add)
Dead Band (add)
Refresh Rate (add)
Angle Sensor (add)
Control System (add)
Programmable (add)
Signal Voltage (add)
Electrical & Environment
Operating Voltage (add)
Power Source (add)
Regulator Type (add)
Temperature (add)
Water Rating (add)
Certification (add)
Idle Current (add)
Connectivity
Connector Futaba J
Wire Length (add)
Origin
Country of Origin (add)

Disclaimer: Most data is sourced from the manufacturer. Some data is sourced from our loyal community and with the help of AI. We aim for accuracy but are not responsible for inaccurate information.

Similar Active Servos

Reviews (6)

  • sid

    January 2, 2017

    Application(s): rc helicopter, raptor 50 tail servo,

    Comments: inside gears gone all off suddenly for no reason,

  • Angel Negron

    November 25, 2014

    Application(s): Raptor 50se Trex 600

    Comments: I've used the same servos over the last 8 yesrs and only replaced 1 set of gears.
    many crashes.
    servo tested today and all check out fine.
    GREAT PRODUCT! !

  • jimboflies

    October 6, 2014

    Application(s): s9254 . EP8 Quick of Japan japan

    Comments: flying this servo on at least 5 helis never a problem

  • phil

    November 7, 2013

    Application(s): tail rotor align 700dfcn

    Comments: small plastic gear fails way to often. no tail strikes or crashes, it seems it lasts about 30 to 40 flights and it strips. im not flying real hard 3d either. for $120 servo it should last longer or put a better gear in or give an extra gear away

  • blade1910

    May 13, 2012

    Application(s): Tail servo for trex 600N

    Comments: This servo last for about 50 flights, then it burned out on my vbar 5.2 . This product is disappointed !!!

  • Krojby

    May 5, 2012

    Application(s): Kyosho caliber 30 tail

    Comments: Absolute perfeft for tail setup on kyosho caliber 30 with GY401 gyro. No problems at all.

Submit a review of Futaba S9254