Discover XQ-Power Servos in Our eBay Store!
Shop Now
Technical Specifications
Last Updated: 2026-07-28Identity
Performance
Physical
Drivetrain
Control & Signal
Electrical & Environment
Connectivity
Origin
Preferences are saved automatically.
| Identity | |
| Brand |  |
| Product Number | HD-1711MG |
| Category | Hobby |
| Discontinued | Yes |
| Performance | |
| Torque |
6.0V48.61 oz-in3.50 kg-cm0.3 N-m |
| Speed |
6.0V0.11 sec/60°545.5 deg/s90.9 RPM |
| Running Current | (add) |
| Stall Current | (add) |
| Shaft Power | 0.82 W |
| Physical | |
| Weight | 0.65 oz18.5 g |
| Dimensions |
L 1.16 in W 0.46 in H 1.19 in L 29.5 mm W 11.6 mm H 30.2 mm |
| Case Material | (add) |
| Drivetrain | |
| Motor Type | (add) |
| Motor Drive | (add) |
| Gears | Metal |
| Gear Spline/Teeth | 25 T estimate |
| Rotation Mode | (add) |
| Rotation/Support | Single Bearing |
| Backlash | (add) |
| Control & Signal | |
| Modulation | Analog |
| Direction | (add) |
| Rotational Range | (add) |
| Mechanical Limit | (add) |
| Pulse Cycle | (add) |
| Pulse Width | (add) |
| Neutral Position | 1500 µs |
| Dead Band | (add) |
| Refresh Rate | (add) |
| Angle Sensor | (add) |
| Control System | PWM |
| Programmable | (add) |
| Signal Voltage | (add) |
| Electrical & Environment | |
| Operating Voltage | 4.8–6 V |
| Power Source | (add) |
| Regulator Type | (add) |
| Temperature | (add) |
| Water Rating | (add) |
| Certification | (add) |
| Idle Current | (add) |
| Connectivity | |
| Connector | JR (Universal) |
| Wire Length | 178 mm7.01 in |
| Origin | |
| Country of Origin | (add) |
Disclaimer: Most data is sourced from the manufacturer. Some data is sourced from our loyal community and with the help of AI. We aim for accuracy but are not responsible for inaccurate information.
Quick Actions
Similar Active Servos
Reviews (4)
-
Acetronics
June 29, 2019Application(s): Glider Ailerons and Flaps
Comments: Those servos work fine ... if not always moving : the amp will burn if used with a Gyro !!! but when used for a thermal glider i.e., they will be fine.
reason is the amplifier really is under what needed ( just look at the final bridge transistors datasheets ... )
so, remember : do not overstress them !!!
Alain
a
October 11, 2016Application(s): s
Comments: d
Kavoth
March 26, 2016Application(s): I used these servo to make hexapod
Comments: After 1.5 hours of testing one servo got bad. Next day two hours into resting two more got bad. Terrible quality.
The gears are not metal as advertised. Only the last two gears are metallic.
raemin
November 26, 2014Application(s): Cyclic for a 450 heli
Comments: This a no-nonsense cheap servo: the metal gear makes it stronger than a Hitec HS81, but it feels slower and the centering resolution is inferior.
A reliable servo but not precise. Nice for airbrakes, nose wheel, etc...