Discover XQ-Power Servos in Our eBay Store!

Shop Now
Hitec HS-5070MH
Micro

Hitec HS-5070MH

Compatible Hardware

*Based on known specs.

Technical Specifications

Last Updated: 2026-10-23
Identity
Brand Hitec
Product Number 35070S
Category Hobby
Performance
Torque
7.4V 53.00 oz-in
6.0V 42.00 oz-in
Speed
7.4V 0.12 sec/60°
6.0V 0.15 sec/60°
Running Current
7.4V 0.240 A
6.0V 0.200 A
Stall Current 1–1.3 AAverage
Physical
Weight 0.45 ozAverage
Dimensions L 0.93 in
W 0.46 in
H 1.18 in
Case Material Plastic
Drivetrain
Motor Type 3-pole
Gears Metal
Gear Spline/Teeth 25 T
Rotation/Support Single Bearing
Backlash 0.500°
Control & Signal
Modulation Digital
Rotational Range 175°
Pulse Width 900-2100 µs
Neutral Position 1500 µs
Dead Band 2 µs
Angle Sensor Potentiometer
Control System PWM
Programmable Yes
Electrical & Environment
Operating Voltage 3.5–8.4 V
Power Source 2S LiPo
Temperature -20–60 °C
Idle Current 0.008 A
Connectivity
Connector JR (Universal) estimate
Wire Length 160 mm

Disclaimer: Most data is sourced from the manufacturer. Some data is sourced from our loyal community and with the help of AI. We aim for accuracy but are not responsible for inaccurate information.

Class Comparison

WeightAverage
Lighter than 40% of 665 Digital Micro servos
Stall CurrentAverage
Lower draw than 39% of 222 Digital Micro servos

Performance Analysis

Shaft Power 0.52–0.82 W
Power Density1.618 W/in³
More power-dense than 45% of 625 Digital Micro servos
Torque Density3.3071 oz-in/g
Torque-to-Volume Ratio83.20 oz-in/in³
Speed-to-Weight0.52493 (1/sec·g)
Speed-Torque Trade-off6.30
Current-per-Torque Ratio0.0310 A/oz-in
Idle-to-Running Current Ratio0.040
No-Load vs Stall Current Spread6.50
Voltage Range Width4.9 V
Wider voltage range than 99% of 553 Digital Micro servos
Backlash-to-Range Ratio0.00286
Tighter backlash than 57% of 43 Hitec servos
Dead-Band-to-Pulse-Width Ratio0.0017
Finer dead band than 42% of 220 Digital Micro servos

Similar Active Servos

Reviews (2)

Includes 2 reviews aggregated from around the web.

There are very few reviews for this servo on the web. One 3D-aerobatic pilot who swapped it in for older servos found it much stronger, with noticeably quicker roll at high speed. He ran it at 8V and called it stinking solid, so he planned to back it down to 7.4V to prolong its life.

Be the first to review!

Submit a review of Hitec HS-5070MH